Manually set Bridging Angle #340
Labels
enhancement
optimize for some feature or user interface
Comments
|
This is also available in Simplify 3D and can be essential. |
|
Will be included in next release about changing the angle of external bridge manually |
|
Thank you! Great to hear!
From: SaltWei ***@***.***
Sent: Thursday, November 10, 2022 4:08 AM
To: bambulab/BambuStudio
Cc: wirlybird; Comment
Subject: Re: [bambulab/BambuStudio] Manually set Bridging Angle (Issue #340)
Will be included in next release about changing the angle of external bridge manually
—
Reply to this email directly, view it on GitHub <#340 (comment)> , or unsubscribe <https://github.com/notifications/unsubscribe-auth/AGB3OKFWW736LLRZEYZQDQDWHTCRTANCNFSM6AAAAAAQY5UZQA> .
You are receiving this because you commented. <https://github.com/notifications/beacon/AGB3OKC2VD3YFCBEVBWUJ5TWHTCRTA5CNFSM6AAAAAAQY5UZQCWGG33NNVSW45C7OR4XAZNMJFZXG5LFINXW23LFNZ2KUY3PNVWWK3TUL5UWJTSOCXEVK.gif> Message ID: ***@***.***>
|
lanewei120
pushed a commit
that referenced
this issue
Dec 15, 2022
In some complicated cases or irregular shape, the direction of external bridge is not good when calculated automaticlly. So user may use modifier to change bridge direction. This is handling for github issue #340 Signed-off-by: salt.wei <[email protected]> Change-Id: I3baf313f47925fa7e6aa087f5896b0af560f902d
lanewei120
pushed a commit
that referenced
this issue
Dec 15, 2022
In some complicated cases or irregular shape, the direction of external bridge is not good when calculated automaticlly. So user may use modifier to change bridge direction. This is handling for github issue #340 Signed-off-by: salt.wei <[email protected]> Change-Id: I3baf313f47925fa7e6aa087f5896b0af560f902d
|
This is included in v1.4. |
veevee2
pushed a commit
to veevee2/BambuStudio
that referenced
this issue
Mar 19, 2023
|
Got the same problem with the same part in combination with other parts on the plate. I would like to change the bridging angle only for this part. Is it possible to add the bridging angle option to the object based settings? |
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
In PrusaSlicer there is an option to change the angle of bridges. This is useful when I embed rectangular magnets in my prints. the default angle sometimes goes the longer direction; when I'd rather them go the shorter direction. I also use the setting with modifiers to handle the situation where I have two magnets in different directions.
The text was updated successfully, but these errors were encountered: