Gateway configuration
The Dusun gateways are configured through a web service which means the gateways should be connected with a computer first. The Dusun gateway can be connected through wired connection and Wi-Fi connection.
The two RJ45 ports gateway includes a WLAN port and a LAN ports. The wired connection of this type gateway is shown figure 2-A. Users can use the gateway default LAN IP address: 192.168.66.1 to connect it.
Figure 2-A Direct connection
The one RJ45 port gateway includes a WLAN port only. The wired connection of this type gateway is shown in below Figure 2-B. A router is used to ensure the gateway and the PC are in the same local area network. Users should log into the router to check the gateway’s IP address for connecting it.
Figure 2-B Connection via a router
After the above physical connection is completed, please open a web browser on PC, Input Gateway IP address；Enter the username and Password（default Username: root Password: root），login to the gateway.
The Dusun gateway supports WIFI connection to login it, but WIFI is not enabled default. The WIFI should be enabled first if user want to use WIFI to connect a gateway. Users should login the gateway through the above wired connection to enable the WIFI module. After the connection is established, please follow the below steps to enable WIFI:
-
Login the gateway (see above figure);
-
Select Dusun > Wifi Manage.
- Enable Device Radio0 and configure Wifi Interface Wlan0（Wifi Mode:ap, Wifi SSID: Input your own; WIFI Encryption: PSK2 or others; WIFI key: your password）
- Click the Save & Apply button, and waiting the changes to be applied.
- Then we can connect the Wifi(for this case:Dusun123) and connect the gateway through Wifi.
After the connection between the gateway and computer is established, the gateway can be configured following these steps:
-
Open a web browser on PC, input the gateway IP address, enter the username and Password （default username: root password: root），login to the gateway;
-
Make system configuration at the system menu, the timezone, password and others can be revised here.
- Configure network at the network sub-memu.
- Change other settings, such as ZigBee 3.0/Z-Wave and MQTT settings.
Zigbee setting
Z-Wave setting
